TAPROGGE Dynamicfilter
An innovative automatic backwash filter for use in fine filtration systems
TAPROGGE’s Dynamicfilter product range can handle fine filtration requirements over a filter fineness range of 50 microns to 5 mm at volumetric flow rates of up to 4,000 m³/h. TAPROGGE has combined two well-known operating principles – “dynamic backwash” and “active filter elements” – to create a cost-effective and reliable filtration solution. The filter is cleaned automatically without interrupting the flow rate to reliably ensure that operator’s facilities can remain permanently available for use.
Technical data
| Volume flow: | up to approx. 4,000 m³/h |
| Nominal connection widths: | DN 80 - DN 600 |
| Filtration grade: | 50 microns – 5 mm |
| Filter element: | “active” plastic filter elements, stainless steel wedge wire, stainless steel perforated plate |
| Housing material: | rubberlined steel, stainless steel, PVC |
| Temperature: | max. 80 °C |
| Controller: | Programmable logic controller |
| Operation: | Pneumatic |
| Special versions: | upon request |
Features and Benefits
Using “active filter elements” increases operational reliability. These “active elements” require much lower backwash velocities than conventional filter elements which often become permanently blocked; this ensures that filtration can continue unimpeded.
In addition, adherence to the “dynamic backwash” principle significantly reduces the amount of flushing water that is required. This reduces operating costs and ensures that the system can be reliably kept clean even when system pressure is low. This product range complies with the European Pressure Equipment Directive 2014/68/EU.
The filters operate automatically and without interruption which ensures that operator’s facilities can remain permanently available for use. This avoids any unplanned stoppages for expensive manual cleaning procedures. The components can be directly installed in the tube system vertically or horizontally and delivery is completed in the Plug&Work standard. This means all components are despatched from the TAPROGGE factory completely preassembled and wired up. Additional fine adjustments to the installation are not required on site which keeps installation costs down to a minimum. The hardwearing construction of the filter also minimises maintenance costs.
References
Over 150 systems delivered
Tel: +49 2335 762-0